2" Drop
Wallace Forge HL62 2" Drop Hitch Bar
- Drop
- 2 in
- Hole to Hole
- 7-7/8 in
- Max GTW
- 10,000 lb
Your browser is out of date.
You are currently using Internet Explorer 7/8/9, which is not supported by our site. For the best experience, please use one of the latest browsers.
Bruce Industrial supplies Wallace Forge solid forged hitch bars for trucks and work vehicles that pull trailers and equipment. Each bar fits a 2" receiver tube, takes a 5/8" hitch pin, and has a 1" ball hole. Choose a 2", 4", or 6" drop to bring the trailer level with your truck.
2" Drop
4" Drop
6" Drop
Park the truck and trailer on level ground with the trailer sitting level. Measure from the ground to the top inside edge of the receiver opening, then to the bottom of the trailer coupler. The difference is about the drop, or rise, you need.
For a small height gap, common when truck and trailer heights are close. Compact 7-7/8" hole-to-hole length. Flip it over for about 2" of rise.
Shop the HL62For a lower trailer behind a taller truck. Same compact 7-7/8" length as the HL62. Flip it over for about 4" of rise.
Shop the HL64For tall or lifted trucks pulling low trailers. A longer 9-1/2" hole-to-hole length adds bumper and tailgate clearance. Flip it over for about 6" of rise.
Shop the HL66Check every rating in the setup. Your towing limit is the lowest rating among the truck, receiver, hitch bar, ball, and pin. A 10,000 lb hitch bar does not raise the rating of a lighter receiver or ball.
Wallace Forge also makes these bars with a 3/4" or 1-1/4" ball hole. Not sure which drop fits your truck? Call us or send a message and we'll get back to you.
Each Wallace Forge high low bar is forged from one piece of steel, with no welded joints, and finished in black powder coat to help resist corrosion. Wallace Forge has made truck and trailer parts in Canton, Ohio since 1942. All three bars carry the same rating, 10,000 lb maximum gross trailer weight and 1,000 lb maximum vertical load. They differ in drop and length.
Every hitch bar on this page can be ordered online by part number. Hitch balls and pins are sold separately, so pair your bar with a ball that has a 1" shank and a 5/8" hitch pin. Need several bars or a part we don't list? Request a quote and our team will follow up.
A high low hitch bar is a drop hitch you can install either way up. With the drop facing down, it lowers the ball to meet a trailer that sits lower than your receiver. Flipped over, it raises the ball for a trailer that sits higher.
With the truck and trailer level, measure from the ground to the top of the receiver opening, then to the bottom of the trailer coupler. The difference is about the drop you need. Bruce Industrial carries 2", 4", and 6" drop bars. If you're between sizes, call our team before ordering.
The HL62, HL64, and HL66 take a 5/8" hitch pin, fit a 2" receiver tube only, and have a standard 1" ball hole. Wallace Forge rates each bar at 10,000 lb maximum gross trailer weight and 1,000 lb maximum vertical load.
The standard ball hole is 1", so you need a ball with a 1" shank. Make sure the ball's rating meets or beats your trailer weight, since the lowest-rated part sets the limit for the whole setup.
No. The HL62, HL64, and HL66 are sold as the bar only. Pair one with a hitch ball and hitch pin from our store.
Wallace Forge also makes these bars with a 3/4" or 1-1/4" ball hole. Contact Bruce Industrial to ask about ordering one.